Service menu
In the following table, items that have an asterisk (*) indicate the factory default setting.
Menu item
Sub-menu item
Sub-menu item
Description
Fax Service
Clear Saved Faxes
Clears all faxes in memory.
Run Fax Test
Performs a fax test to verify that the phone cord is plugged
in the correct outlet and that there is a signal on the phone
line. A fax test report is printed indicating the results.
Print T.30 Trace
Now
Never
*
If Error
At End of Call
Prints or schedules a report that is used to troubleshoot fax
transmission issues.
Error Correction
On
*
Off
The error correction mode allows the sending device to re-
transmit data if it detects an error signal.
Fax Service Log
The fax service log prints out the last 40 entries in the fax
log.
Cleaning Page
Cleans the product when specks or other marks appear on
printed output. The cleaning process removes dust and
excess toner from the paper path.
When selected, the product prompts you to load plain
Letter or A4 paper in Tray 1. Touch the
OK
button to begin
the cleaning process. Wait until the process completes.
Discard the page that prints.
NOTE:
For models that do not have an automatic
duplexer, the product prints the first side and then prompts
you to remove the page from the output bin and reload it in
Tray 1, keeping the same orientation.
USB Speed
High
*
Full
Sets the USB speed for the USB connection to the
computer. For the product to actually operate at high
speed, it must have high speed enabled and be connected
to an EHCI host controller that is also operating at high
speed. This menu item also does not reflect the current
operating speed of the product.
Less Paper
Curl
On
Off
*
When printed pages are consistently curled, this option
sets the product to a mode that reduces curl.
Archive Print
On
Off
*
When printing pages that will be stored for a long time, this
option sets the product to a mode that reduces toner
smearing and dusting.
Firmware
Datecode
Displays the current firmware datecode
26
Chapter 2 Control panel menus
ENWW
Menu item
Sub-menu item
Sub-menu item
Description
Restore
Defaults
Sets all settings to the factory default values
HP Smart
Install
On
*
Off
Enable or disable the HP Smart Install tool.
Disable the tool if you want to connect to a network by
using an Ethernet cable.
If you disable HP Smart Install, you must use the product
software CD to install the product software.
ENWW
Setup Menu
27