Network Setup menu
In the following table, items that have an asterisk (*) indicate the factory default setting.
Menu item
Sub-menu item
Sub-menu item
Description
Wireless Menu
NOTE:
You can also
access this menu by
touching the Wireless
button on the control
panel.
Wireless Direct Settings
Wireless Direct On/Off
Enables or disables the Direct Wi-Fi wireless access
feature.
Wireless Direct Name
Set the product's Direct Wifi name, so you can access it
from other wireless devices that support the Wi-Fi Direct
protocol.
Wireless Direct Mode
Set the product's Direct Wifi mode.
●
Select the
Print Only
option (the default setting) to
allow wireless access to only the product print
functions from a mobile device.
●
Select the
Open Network
option to allow wireless
access to all product functions and settings from a
mobile device.
Wireless Setup Wizard
Guides you through the steps to set up the product on a
wireless network
Wi-Fi Protected Setup
If your wireless router supports this feature, use this
method to set up the product on a wireless network. This
is the simplest method.
Run Network Test
Tests the wireless network and prints a report with the
results.
Turn Wireless On/Off
Enables or disables the wireless network feature.
TCP/IP Config
Automatic
*
Manual
Automatic
: The product automatically configures all the
TCP/IP settings via DHCP, BootP or AutoIP.
Manual
: You can manually configure the IP address,
subnet mask, and default gateway. The control panel
prompts you to specify values for each address section.
As each address is completed, the product prompts for
address confirmation before moving to the next one. After
all three addresses are set, the network reinitializes.
Auto Crossover
On
*
Off
Enables or disables the use of a standard 10/100 network
cable when the product is directly connected to a
computer.
Network Services
IPv4
IPv6
Enable or disable the IPv4 and IPv6 protocols. By default,
each protocol is enabled.
Link Speed
Automatic
*
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically
restarts.
28
Chapter 2 Control panel menus
ENWW
Menu item
Sub-menu item
Sub-menu item
Description
HTTPS Enforcement
Yes
No
*
Sets the product so that it communicates only with Web
sites that use hypertext transfer protocol secure (HTTPS).
Restore Defaults
Resets all network configurations to their factory defaults.
ENWW
Setup Menu
29